(pointing to fuel, oil, paddle wheel harness) Here is an image of the area with the two smart craft harnesses connected (blue network cable, and Fuel, oil, and paddle wheel harness) Here is the rough overview of my install in my 2008 PolarKraft Kodiak 178 FS with a 150hp optimax.įirst was the completely unknown connector in the engine, this was easly found once I knew that there had to be a terminator resistor on it, so you look for a connector that ends (near the front righthand side) that has a yellow cap that reads "terminator" keep it, you will need it. I can help you with part numbers, harnesses, connectors etc. I took the leap, taught myself a lot and would like to share with you guys how to do it.
If you have any questions, please post it on this forum, not by PM I was like many of you (I can tell by all of the questions floating around on these forums), wanting to install a smartcraft system in my boat, but found there is little accurate info out there.
0 kommentar(er)
